 |
| Purchase Information |
| Use this form to request purchase information on IEEE online subscriptions. |
|
|
Document IEEE 625 is offered by IHS as part of an online subscription. This subscription contains many documents on the same topic.
You may also purchase this document alone from the IHS Standards Store.
IEEE 625 Document Information:
Title
Recommended Practices to Improve Electrical Maintenance and Safety in the Cement Industry
The Institute of Electrical and Electronics Engineers, Inc.
Publication Date:
Jan 1, 2001
Scope:
Forward
(This introduction is not a part of IEEE Std 625-2001, IEEE Recommended Practices to Improve Electrical Maintenance and Safety in the Cement Industry.)
Continuing efforts to improve safety and working conditions in the cement industry have made safety increasingly important to the management of every cement plant. Proliferating federal, state, and local laws have placed even greater stress on the need for a good maintenance and safety program. The Cement Industry Committee has analyzed many areas to which safety requirements pertain and, through the working groups, recommended practices have evolved for the industry.
Several years ago, the Safety Committee Working Group published its safety recommendations for the cement industry. At that time, no attempt was made to cover recommended maintenance practices in cement plants; the present recommended practices, however, combine both maintenance and safety practices. This approach was agreed on by the Environmental, Maintenance and Safety Working Group and is based on the belief that sound maintenance practices go, of necessity, hand-in-hand with safety. As in the previous recommended practices, IEEE Std 625-1979 and IEEE Std 625-1990, the recommendations contained here are advisory and should be considered in that light. The Environmental, Maintenance and Safety Working Group have agreed on these recommendations, but they recommend that they be revised in the future to suit specific plant conditions. In general, however, it is hoped that these practices can provide sound, basic guidelines for the industry at present.
For these recommendations to be of maximum use to the cement industry, the users’ comments are required. Comments should be concerned with areas not covered in these recommended practices, as well as with those requiring greater coverage in subsequent reports.
This document was revised by the Environmental, Maintenance and Safety Working Group of the Cement Industry Committee. The members of the working group were as follows:
Christopher Macey, Chair
Christopher C. Rayner, Vice Chair
Neal W. Biege
Mark A. Huber
Satish H. Sheth
Ed Buehler
Larry D. McConnell
Diana L. Smith
Cary O. Cohrs
A. S. (Allan) Moore
John Sommers
Guy Cosway
Robert J. Sagmeister
Charles E. Wilber
Ann Dougherty
Karl A. Willis
The following members of the balloting committee voted on this standard:
Leroy C. Cockrell
Andrzej Janik
R. Joseph Pospisil
Cary O. Cohrs
Michael W. Jasberg
Christopher C. Rayner
Stephen J. Coppinger
Brian P. Keefe
Clayton H. Reid
Thomas K. Crowninshield
John P. Kline
Paul J. Riley
Ennio Dezorzi
William Kohan
James L. Schaadt
Ann Dougherty
Christopher Macey
Satish H. Sheth
Reinhold A. Errath
Larry D. McConnell
Roderick H. Simmons
When the IEEE-SA Standards Board approved this standard on 14 March 2001, it had the following membership:
Donald N. Heirman, Chair
James T. Carlo, Vice Chair
Judith Gorman, Secretary
Chuck Adams
James H. Gurney
Paul J. Menchini
Mark D. Bowman
Raymond Hapemen
Daleep C. Mohla
Clyde R. Camp
Richard J. Holleman
Robert F. Munzner
Richard DeBlasio
Richard H. Hulett
Ronald C. Petersen
Harold E. Epstein
Lowell G. Johnson
Malcolm V. Thaden
H. Landis Floyd
Joseph L. Koepfinger*
Geoffrey O. Thompson
Jay Forster*
Peter H. Lips
Akio Tojo
Howard M. Frazier
Howard L. Wolfman
*Member Emeritus
Also included are the following nonvoting IEEE-SA Standards Board liaisons:
Satish K. Aggarwal, NRC Representative
Alan H. Cookson, NIST Representative
Donald R. Volzka, TAB Representative
Savoula Amanatidis, IEEE Standards Managing Editor
Scope
These recommendations apply to all electrical equipment such as substations, power transformers, motor controls, generators, distribution systems, instruments, and storage batteries commonly used in cement plants. They are intended to be used as a guide and may be supplemented where special needs exist. This document is a companion document to IEEE Std 277-1994, IEEE Recommended Practice for Cement Plant Power Distribution [B1] and IEEE Std 499-1997, IEEE Recommended Practice for Cement Plant Electric Drives and Related Equipment [B3]1.
About IHS
IHS (NYSE: IHS) is a leading global provider of critical technical information, decision-support tools and related services in a number of industries including aerospace and defense, automotive, construction, electronics, and energy. IHS serves customers ranging from large governments and multinational corporations to smaller companies and technical professionals in more than 100 countries. IHS been in business for more than 45 years and employ more than 2,300 people around the world.
